View Single Post
Old 09-01-2019, 09:31 AM   #18
tw
Read? I only know how to write.
 
Join Date: Jan 2001
Posts: 11,275
Picture quality is similar in all models. All that is standardized. Serious problems exist with discount TVs (ie Seiki). The controls are bogus. Its CPU sometimes can take up to 10 seconds to respond to some remote functions. Or the remote receiver only receives in certain directions.

For example, a better TV should put up the Sleep function without going into the Setup section. Samsungs do that. Elements and some other discount brands require searching in other categories.

TVs are so easily repaired. For example, the board that includes functions such as HDMI was replaced on a 60 inch Element TV for about $80. It is only one board so it is the only part that has a defect. Only needed was a screw driver, needle nose pliers, and care with what screw goes where.

If only used to play games, then any old TV (with HDMI) is just fine - even one without tuner functions and remote. Craigslist is also a good source since so many discover later that they need to eliminate the Element or Seiki due to poor remote response times and function layouts.

Ability to switch from TV to other input devices is embedded even in Comcast remotes. But Comcast conveniently makes that function not work. Comcast controllers can select the input pages on a TV (setup codes for that TV's function are in the remote; just not published). But Comcast does not enable the arrow function. You can view the page but not select the other input ports for those other devices (DVR, game, internet TV) that are not provided by Comcast. You must go find the remote provided by that TV manufacturer. IOW one must keep two remotes available - so that one will eventually get lost.

That recovery technique is bogus. Written by people who have no idea how electronics work. Some electronics have a safety lockout. That lockout is reset only by disconnecting the power cord for a few seconds. Nobody needs the 30 seconds. Holding down the power on button does absolutely nothing.

Power is simply removed for a few seconds. Then everything inside electronics is fully discharged. That also resets the safety lockout (if it exists and if it tripped).

To make TV damage easier, plug that TV into a plug-in protector. Such power strips do not even claim to protect from surges. Better protection inside the TV can be circumvented by a plug-in protector. In FL, other solutions from responsible manufacturers are recommended. And much more necessary that in MI. Using a plug-in protector could explain HDMI damage.
tw is offline   Reply With Quote