Building a bandsaw on the cheap from mostly scrap wood

[glatt]

Sunday 5/22 continued again

With the slots cut, it’s time to make some splines. Through trial and error, I set the fence to the exact distance from the blade to get a good spline thickness. My zero clearance blade insert is critical here so the spline doesn’t fall down into the saw as it is cut. I used some of the last scraps of that maple bed frame to cut a few long skinny splines, and then cut them into triangles with the miter gauge.


And then I started gluing them into place. This was kind of messy. I got glue all over my fingers.


And while the glue on the frame splines dried, I turned my attention to the wheel shafts. I had bought a 2 foot fucking metal bar online, and needed to cut it to length. So I started with the lower shaft. It needed to be 20 centimeters. My son had been using the hacksaw a lot to make various zombie weapons and it had basically no teeth left anymore, so I put a nice new blade on. He saw me do this and was thrilled. The hacksaw will cut again!


I tried to rotate the cut of the hacksaw so it would be held by a thread of steel in the middle of the bar and wouldn’t have a nasty burr on the corner, but even so, the cut was a little rough and I had to file it smooth.