Building a bandsaw on the cheap from mostly scrap wood

[glatt]

4/24/16 Sunday afternoon I had an hour or two.

I mostly just straightened up the shop. The wheels are basically done. I'm going to put the tires on them before I balance them, and the tires (14 inch inner tubes) are coming this week some time. But I put away my wheel turning station and swept the floor, put tools away, etc. I was all out of empty horizontal surfaces and needed room to work.

But I did make some progress. I had an old bed frame I dug out of the neighbor's trash.

It's made of nice thick maple, used as a secondary wood, with some sort of tropical hardwood in the showy places. I tore off that tropical hardwood years ago, and it splintered badly so I threw it away. But I had these nice maple bed frames. I need a big hunk of wood to be the top bearing block, and it's a very intricate shape. So I cut up part of my bed frame and glued it up into a nice block. I wish I had a thickness planer. It would be easier to do this stuff.



It was getting to be dinner time so I stopped there. I'll make all the intricate cuts next time.