|
|
|||||||
| Technology Computing, programming, science, electronics, telecommunications, etc. |
 |
|
|
Thread Tools | Display Modes |
|
|
08-16-2012, 04:56 PM
|
#1 |
|
Lecturer
Join Date: Jan 2001
Location: Carmel, Indiana
Posts: 761
|
Did you try the following?
Open up a Command Prompt (start -> all programs -> accessories -> command prompt) and enter in the following:
netsh winsock reset hit enter after that. That resets the network stack. |
|
|
|
08-16-2012, 05:34 PM
|
#2 | |
|
To shreds, you say?
Join Date: Aug 2004
Location: in the house and on the street-how many, many feet we meet!
Posts: 18,449
|
Quote:
I get "Windows could not finish repairing the problem because the following action cannot be completed: Renewing your IP address" Checked network adapters did a few safemode system restores to a week ago, and ran NPE, I'm not seeing tcp/ipv4. I'm only seeing tcp/ipv6 and tcp/ip. not sure if that is relevant.
__________________
The internet is a hateful stew of vomit you can never take completely seriously. - Her Fobs Last edited by footfootfoot; 08-16-2012 at 05:47 PM. |
|
|
|
|
|
08-16-2012, 10:30 PM
|
#3 |
|
Lecturer
Join Date: Jan 2001
Location: Carmel, Indiana
Posts: 761
|
can you run ipconfig /all from safe mode?
Can you run ipconfig /all from a command prompt in safe mode and tell me the IP?
|
|
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
